The parquet wood flooring is very different from the typical look zone. They were initially consist of many small pieces of exotic woods are located in complex geometric models. Modern hardwood parquet floors consists of a solid ceramic tile from the tree pre-arranged patterns, as a result it is easy to install. The parquet floor hardwood, as the cheapest, but it is far more difficult than in other refinish solid wood floors and his life is relatively short.

The parquet floor is hardwood in many projects ranging from basic parquet to weave baskets and herringbone. They come in a large ceramic tiles are composed of geometric patterns composed of individual wood slats held in place of paper or plastic mesh backing. Visual effects hardwood parquet floors can be quite stunning and diverse can be brought to the room, simply moving furniture from the carpet to expose the cover of different models.

The parquet floors can be attached a specific tree, but south of concrete floors often require underlay to help compensate for any unevenness. Because small pieces located in different directions, leading to less overall cross-grain expansion, parquet is a good choice in areas where there is moisture, is expected to change significantly over time.

The parquet wood flooring comes in various woods such as oak, cherry, mahogany, walnut and beech. This is a good idea to make a dry run of the model need to lay out, laying test equipment before permanent installation.

Wood tiles should be stored in a room they should be installed for at least 24 hours so that they could acclimate to temperature and humidity. You must acquire about 5% more than you half expect that you will need to compensate for any mistakes. Additional material, if not needed, could be useful later in the event of damage.

Unlike the strip or plank flooring, parquet floor is defined in two directions simultaneously. parquet wood flooring should be laid upon starting in the center of the room and working outwards to the walls. This is set in the center and well-coordinated geometric pattern.

Find a center of the room, measuring from wall to wall. Snap chalk lines between the centre opposite wall, and then it even easier to chalk line between two other walls. The intersection between the two lines is a central point. Make sure that the two intersecting lines form at right angles. Lay parquet test run along the chalk lines, starting with the center, working towards the wall. Adjust the center to keep the tiles on the edges of the room from a reduction too thin.

Using the trowel, spread to the adhesive 2 "x 2" in the area of intersection with chalk lines and let it thicken and become tacky. Pressing firmly, to lay down tile adhesive, using lines to accommodate. Ensure the first deployment of tiles is accurate, because it will determine the location of the entire floor. Tap tiles into place with mallet, placing a piece of scrap metal at the top of the tree to protect the tiles. If any glue seeps between the tiles with a clean cloth soaked in solvent. Working to each wall, fill one quadrant at the time. To avoid putting your weight on any one tile, use a piece of plywood, both on board the knees.

Last tile against the wall will need to be reduced to a landing. They should be cut slightly smaller than the space is measured to ensure the expansion of wood.